Samsung SF-565P-XAA - Manual (Page 59)

P APER H ANDLING
2.4
- To avoid smudging caused by fingerprints, handle them and
coated paper carefully.
- To avoid fading, do not expose the printed transparencies to
prolonged sunlight.
• For labels:
- Verify that their adhesive material can tolerate fusing
temperature of 200 o C (392 o F) for 0.1 second.
- Make sure that there is no exposed adhesive material
between them. Exposed areas can cause labels to peel off
during printing, which can cause paper jams. Exposed
adhesive can also cause damage to machine components.
- Do not load a sheet of them through the machine more than
once. The adhesive backing is designed for one pass
through the machine.
- Do not use labels that are separating from the backing
sheet or are wrinkled, bubbled, or otherwise damaged.
• Do not use Carbonless paper and Tracing paper. They could
make smell of chemicals and damage your machine.
Selecting an Output Location
The machine has two output locations; the rear output slot (face
up) and the front output tray (face down).
To use the front output tray, make sure that the rear cover is
closed. To use the rear output slot, open the rear cover.
N
OTES :
• If paper coming out of the front output tray has problems, such
as excessive curl, try printing to the rear output slot.
• To avoid paper jams, do not open or close the rear cover while
the machine is printing.