Samsung LN32A620A1FXZA User Manual
Page 123
English - 121
Charging the Clone Remote Control
Clone Remote Control
Wall
Connect the charger connector to supplied charging equipment.
- It takes about two hours to charge the battery fully from a completely discharged state.
- Depending on button usage, a fully charged battery will last a minimum of 15 hours, and a maximum of 90.
- The battery usage time may be different according to the usage conditions.
- The battery lifetime becomes shorter as the product use time becomes longer.
Installing Battery in the Clone Remote Control
1. Lift the cover at the back of the remote control upward as shown in the figure.
2. Install the battery. (model: AB483640CA, type: 3.7 V Li-ion)
3. Replace the cover.
CALIFORNIA USA ONLY
This Perchlorate warning applies only to primary CR (Manganese Dioxide) Lithium coin cells in the product sold or
distributed ONLY in California USA
‘Perchloate Material - special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate:’
BN68-01800A-01Eng.indb 121
2008-10-24 �� 10:44:47