Samsung HPS6373X-XAA User Manual
Page 61
English-61
3. Tighten the 6 screws in step 2 (plastic hanger + screw
) to the
rear holes of the product.
4. Remove safety pin (
#
) and insert the 4 product holders into the
corresponding bracket holes (
!
). Then place the product (
@
) so
that it is firmly fixed to the bracket. Make sure to reinsert and tighten
the safety pin (
#
) to securely hold the product to the bracket.
PDP
Wall Bracket
Plastic Hanger
Wall
Note: Please secure the mounting bracket on the wall surface after setting its angle at 0°
1. Secure the SET to the wall mount bracket.
(Please refer to the following instructions.)
2. Set the angle by pulling the upper end of the SET attached to
bracket in the direction of the arrow.
(Refer to the illustration on the right.)
3. The angle can be adjusted from 0° to 15° by ±2°.
Hold onto the middle of the PDP to
adjust the angle (not the sides of the
PDP).
How to Adjust Mounting Angle
Note: To connect external devices such as a DVD or a Home Theater System to the PDP, please refer to following instructions:
1. Be sure to remove the safety pins underneath the PDP.
Note: If the safety pins are not removed, the angle cannot be adjusted.
Any attempt to do so may cause damage to the PDP.
2. Hold onto the bottom of the PDP and pull forward fully as directed by the arrow as illustrated)
to adjust the angle. (0°~20° by 2°) Insert the Safety Pins to the front guide holes on both
sides as illustrated in figure @.
Note: Viewing the PDP after connecting the external devices Remove the Safety Pins
to adjust the angle to 0°, and then secure the Safety Pins again.
• For safety, be sure to secure the PDP using the safety pins. If the safety pins are not used,
the PDP may fall, causing serious injury.
Connecting External Devices to the PDP
BN68-00991Q-01Eng 8/8/06 4:46 PM Page 61