Operating tips, Perating, Oading – Samsung DB5710DT User Manual

Page 3: Before you start, Operating the dishwasher, Adding a forgotten item, General recommendations

Advertising
background image

2

Before You Start

Don’t prerinse. Simply scrape off any bones or

large food particles.

• If connected to a food waste disposer, make certain

the disposer is empty before starting the
dishwasher.

Scrape off tomato-based food soils (see page 11).

Remove certain foods such as mustard,

mayonnaise, lemon juice, vinegar, salt or dressings
from stainless steel flatware as soon as possible.
These foods may cause rusting and pitting if allowed
to remain in contact with the surface for an extended
period of time.

Operating the Dishwasher

1. After loading the dishwasher and adding detergent,

select the desired cycle and options by pressing
the pads. The indicator lights for the selected cycle
and options will illuminate. To cancel an option
press the pad again.

2. To start a cycle, close the door until it latches then

press the START/Cancel pad once. After a pause,
the fill will begin. The display countdown will flash
until START/Cancel is pressed.

Note

• If START/Cancel is not pressed within 30

seconds of choosing your cycle, the dishwasher
will turn off.

The dishwasher remembers your last cycle so you
do not have to reset the cycle each time. To start
the dishwasher using the same cycle and options
selected on the previous wash, just press the
START/Cancel pad.

3. To cancel a running cycle, press the

START/Cancel pad once. The dishwasher will
drain, then shut off. To turn the dishwasher off
without draining, press the START/Cancel pad
twice. To prevent unplanned cycle or option
changes, these selections are “locked in” after 1
minute.

Note

• If a cycle pad is pressed after the controls have

been “locked in”, the light above the current cycle
will flash three times.

Adding a Forgotten Item

For best cleaning, the forgotten item should be added
early in the cycle.

1. Grasp door handle and unlatch door without

opening completely. All lights will flash to indicate
that the cycle is suspended.

2. Wait for the water circulation to stop.

3. Open the door and add the item.

4. Close and latch the door. Lights will stop flashing

when the door is properly shut. After a slight delay,
the cycle resumes automatically at the point of
interruption.

Notes

• If the door is opened during a running cycle,

there may be up to a 30 second delay before the
dishwasher restarts after closing the door.

• Extended interruption of the wash cycle is not

recommended.

General Recommendations

(Rack features vary by model)

• Items can be centered behind a single tine or loaded

at an angle to maximize space.

• Avoid blocking or preventing the spray arms from

spinning freely. Do not allow items to extend beyond
the racks.

• Face soiled surfaces toward the center of the

dishwasher.

For best dishwashing results follow guidelines on
following pages to determine the best arrangement for
your items.

cont.

O

PERATING

T

IPS

L

OADING

Advertising
This manual is related to the following products: