Samsung HLS5686CX-XAA - Manual (Page 78)

English-78
Using the OCAP (OpenCable Application Platform) Data Service
TV Rear Panel
Please insert the
card as shown.
You must obtain a CableCARD from a local cable service provider.
Connecting CableCARD
1. Plug the incoming cable into the ANT 1 IN (CABLE) terminal on the back of the TV.
The CableCARD recognizes input signals from ANT 1 IN (CABLE).
2. Insert the CableCARD into the “CableCARD” slot and the message “CableCARD TM ‚
Inserted” is displayed.
3. Within a few minutes after step 2, the message is displayed with a phone number to
call for activating the CableCARD. This message contains the CableCARD ID and
Host ID numbers of your TV, which records these numbers in preparation for
activation.
ANT 1 IN
(CABLE)
4. After activation, the cable provider will send activation messages to the CableCARD.
During this operation, the message “Updating Channel List” is displayed. When the
“Updating Channel List” process is completed, the message “Updating Completed” is
displayed and your TV will switch to an active channel.
5. Within a few minutes after step 4, the message “Receiving Data Service Signal” is
displayed and disappears.
In order to start service for
this device, please contact
customer sevice at
PH# 888 705-7171
CableCARD(tm): 0-010-405-737-577
Host ID: 0-020-174-928
6. The TWC ODN loading screen is displayed. (Loading screen number start from 14 to 1.)
T I M E W A R N E R
C A B L E
Initializing, please wait...
MAC ID Number
Serial Number
Weak or no signals.
Updating Channel List
14
BP68-00620A-00Eng 9/14/06 5:28 PM Page 78