Samsung HLS5686CX-XAA - Manual (Page 9)

English-9
Viewing the Control Panel
SPEAKERS
(POWER)
Press to turn the TV on and off.
REMOTE CONTROL SENSOR
Aim the remote control towards this spot on the TV.
INDICATOR LIGHTS
SOURCE
Toggles between all the available input sources
(TV, AV1, AV2, AV3, S-Video1, S-Video2, S-Video3,
Component1, Component2, HDMI1, HDMI2).
MENU
Press to see an on-screen menu of your TV’s features.
– VOL +
Press to increase or decrease the volume.
In the on-screen menu, use the – VOL + buttons as you
would use the
and buttons on the remote control.
CH
Press to change channels.
In the on-screen menu, use the
CH buttons as
you would use the and buttons on the remote
control.
(ENTER)
Press to confirm a selection.
Buttons on the Lower-Right Part of the Panel
The buttons on the lower-right panel control your TV’s basic features, including the on-screen menu.
To use the more advanced features, you must use the remote control.
TIMER
Standby state.
The picture will automatically appear in about 15 seconds.
Auto Timer ON/OFF has been set and the set will automatically be turned on in
about 15 seconds.
A cooling fan inside the set is not operating normally.
Lamp cover on the rear of the set is not properly shut.
Check if the ventilation hole on the rear of the set is blocked, because if the inner
temperature is too high, the power will shut off.
Lamp may be defective. Please contact a certified technician.
LAMP STAND BY/TEMP Indication
• It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.
• The TV has a fan to keep the inside lamp from overheating. You’ll occasionally hear it working.
: Light is On / : Light is Blinking / : Light is Off
BP68-00620A-00Eng 9/14/06 5:27 PM Page 9