Samsung MX-E650CB-ZA - Manual (Page 7)

6
English English
6
English
7
1
1
2
2
3
3
4
4
1. 2.0 CH Speaker Connector Terminals
(MX-E630CB only)
2.1 CH Speaker Connector Terminals
(MX-E650CB only)
The speaker connector terminals are located on
the rear of the system.
1. To achieve the correct sound quality, insert
the speaker connector cables identified
below into the correct speaker terminals on
the back of the system.
• Left speaker (marked L).
• Right speaker (marked R).
• SUBWOOFER speaker: MX-E650CB only.
2. ONLY FOR SERVICE
• This jack is for service only. Please do not
use.
3. AUX IN Terminals
1. Use an Audio Cable (not supplied) to con-
nect AUX IN on the product to Audio Out on
an external analog component.
• Be sure to match connector colors.
• If the external analog component has only
one Audio Out jack, connect to either
the left or right terminal.
• Press the TUNER/AUX button to select the
AUX input.
• You can also select AUX by pressing the
FUNCTION button on the remote control.
4. FM Antenna Connector Terminal
1. Connect the FM antenna (supplied) to the
FM Antenna jack.
2. Slowly move the antenna wire around until
you find a location where reception is
good, then fasten it to a wall or other rigid
surface.
3. If reception is poor, you may need to install
an outdoor antenna. To do so, connect an
outdoor FM antenna to the FM socket on
the rear of the system using a 75Ω coaxial
cable (not supplied).
Rear Panel
MX-E630CB
MX-E650CB
MX-E630CB-E650CB-ENG-XAA-0710.indd 7 2012-7-10 10:49:11