Samsung HT-X200T-XAA - Manual (Page 8)

ENG
CONNECTIONS
15 14
Installing the Main Unit
• Be careful not to scratch the surface the DVD Player when installing
the stand.
• Do not turn the DVD Player left or right as it may separate it from the stand.
Method 1 : Installing the Stand so that the DVD Player Lays Flat.
Preparation
■ Disconnect the AC power cord from the AC outlet before installing the main unit.
■ Connect the cables before installation.
Method 2 : Installing the Stand so that the DVD Player Stands up.
Arranging the Cables
Preparation
■ Disconnect the AC power cord from the AC outlet before installing the main unit.
■ Connect the cables before installation.
1 Turn the stand counter-clockwise and pull it apart.
■ The DVD Player and stand are separated.
2 Hold the DVD Player and stand as shown by the figure and turn
the right side of the stand upward so that it is slightly slanted.
3 Insert the 2 stand anchors into the holes on the back of the
DVD Player.
4 Turn the right side of the stand clockwise to fix it to the back of the
DVD Player.
1 Turn the stand in the direction of the arrow and pull it apart.
■ The DVD player and stand are separated.
2 Lift the right side of the stand so that it is slightly slanted.
3 Insert the 2 stand anchors into the holes on the bottom of the
DVD Player.
4 Turn the right side of the stand clockwise to fix it to the bottom of the
DVD Player.
Use the cable tie to keep the cables together.
1 2 3 4 1 2 3 4