Samsung HT-HM55-ZA - Manual (Page 20)

20
- English
Settings
✎ You can get the Network parameter values
from your Internet provider.
11. When finished, select Return ('), and then
press the v button. The Security key screen
appears.
12. On the Security key screen, enter your
network's Security Code or Pass Phrase. Enter
numbers directly using the number buttons on
your remote control. Enter letters by selecting
a letter with the ▲▼◀▶ buttons, and then
pressing the v button.
13. When finished, select done at the right of the
screen, and then press the v button. The
product verifies the network connection and
then connects to the network.
14. After the home theater verifies the network,
select Ok, and then press the v button.
✎ You can also begin the Manual Network setup
by going to Settings > Network > Network
Status.
Ğ WpS(pBC)
One of the easiest ways to set up the wireless
network connection is using the WpS(pBC) function.
If your wireless router has a WpS(pBC) button,
follow these steps:
Follow the Steps 1 to 3 in "Configuring Your
Network Connection". (See page 18)
1. In the Network Settings screen, change
Network Type to Wireless. The product searches
for and then displays a list of the available
networks.
2. Scroll the list down, select WpS(pBC), and then
press the v button.
3. Press the WpS(pBC) button on your router
within two minutes. Your product automatically
acquires all the network settings values it
needs and connects to your network after the
network connection is verified.
4. When it is done, highlight Ok, and then press
the v button.
✎ For a WPS connection, set your wireless
router’s security encryption to AES. WEP
security encryption does not support a WPS
connection.
Wi-Fi Direct
The Wi-Fi direct function allows you to connect Wi-
Fi direct devices to the product and each other using
a peer-to-peer network, without a wireless router.
✎ Some Wi-Fi direct devices may not support
the DLNA function if connected via Wi-Fi
direct. If this is the case, change the network
connection method you used to connect the
device to the home theater.
✎ Wi-Fi direct transmissions can interfere
with Bluetooth signals. Before you use the
Bluetooth function, we strongly recommend
that you turn off the Wi-Fi direct function on
any device in which it is currently on.
1. Turn on the Wi-Fi direct device and activate its
Wi-Fi direct function.
2. In the Home screen, select Settings, and then
press the v button.
3. Select Network, and then press the v button.
4. Select Wi-Fi direct, and then press the v
button.
The Wi-Fi direct devices that you can connect
to appear.
Settings
Display
Audio
Network
System
Language
Security
General
Support
Wi-Fi Direct
Device Name : HT-HM55
Select your Wi-Fi Direct device to connect to.
AndroidXXXXXXX Not Connected
Close
Refresh
5. You have three ways to complete the Wi-Fi
connection:
●
Through the Wi-Fi device.
●
Through the product using PBC.
● Through the product using a PIN.
Each is covered below.
Through the Wi-Fi device
1. On the Wi-Fi device, follow the device's
procedure for connecting to another Wi-Fi
direct device. See the device's user manual for
instructions.