Samsung KN55S9CAFXZA - Manual (Page 10)

Inserting the Batteries (AAA X 2)
1 3 2
1. Insert a plastic card into the notch in the battery cover, and then rotate the
card to loosen the battery cover. Carefully pull the cover up to remove it
completely.
✎ Check the location of the battery cover notch The notch's location
may vary depending on the type of Smart Touch Control provided with
the product.
2. Insert 2 AAA batteries, making sure to align the positive and negative ends
correctly.
3. Align the battery cover with the back of the remote control, and then press
down along the edges until it is completely attached to the remote control.
Connecting to the TV
To operate the TV using a Smart Touch Control, you must first pair it to the TV
via Bluetooth. Note that the Smart Touch Control will only work with the paired
Samsung TV.
✎ We recommend to use the Smart Touch Control in less than 20ft(6m).
A usable distance may differ depending on the wireless environmental
conditions.
1. To turn on the TV, point the Smart Touch Control at the remote control
receiver of the TV and press the P button. The remote control receiver's
location may vary depending on the model.
2. A Bluetooth icon will appear at the bottom left of the screen as shown
below. The TV will then attempt to connect to the Smart Touch Control
automatically.
<Attempting to connect> <Connected>
3. If pairing is successful, the TV displays a small green circle between
graphics representing the TV and the Smart Touch.
4. If the Smart Touch does not pair:
a. Remove the battery cover.
b. Aim the Smart Touch at the TV's remote control receiver.
c. Use a pen tip to press and release the pairing button on the back of the
Smart Touch. (See page 11 for its location.)
d. In a few seconds, you should see the Bluetooth icon described in Step
2, and then the Smart Touch should pair.
• The first time you turn on your TV, it will immediately start the initial setup.
English - 10 English - 11
[S9C-ZA]BN68-05356B-02ENG.indb 10 2013-10-30 �� 4:41:47