AEG L 75670 FL - Manual (Page 25)

1
2
9. Clean the filter under the water tap
and put it back in the pump into
the special guides.
10. Make sure that you tighten correct-
ly the filter to prevent leakages.
11. Put the flap back and close the
drain pump door.
THE INLET HOSE FILTER AND
THE VALVE FILTER
It could be necessary to clean the filters
when:
• The appliance does not fill with wa-
ter.
• The appliance fills with the water for
a long time.
• The indicator of button 4 flashes
and the display shows the related
alarm. Refer to 'Troubleshooting'.
WARNING!
Disconnect the mains plug from
the mains socket.
To clean the water inlet filters:
1. Close the water tap.
2. Remove the water inlet hose from
the water tap.
3. Clean the filter in the inlet hose
with a stiff brush.
4. Remove the inlet hose behind the
appliance.
5. Clean the filter in the valve with a
stiff brush or a towel.
45°
35°
6. Install again the inlet hose. Make
sure that the couplings are tight to
prevent leakages.
7. Open the water tap.
EMERGENCY DRAIN
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (6) of
'To clean the drain pump'.
If necessary, clean the pump.
Put the drainage duct back and close
the drain pump flap.
ENGLISH 25