Avaya PARTNER-18D - Manual (Page 76)

6 Maintaining Your System
66 Replacing Modules
Quick Reference Guide
4 For a 2-slot carrier configuration, do the following:
a Remove the long screw at the bottom of the modules.
b Remove the screws that attach the carrier to the modules.
c Pull the carrier to the right to remove it.
d Slide the top module to the left to disengage its interlocking mounting
tracks from the processor module.
If you are replacing the processor module, go to Step e. If you are
replacing the top module, continue with Step g.
e Remove the screw at the top of the processor module, and remove the
module from the wall.
f Mount the new PARTNER ACS processor module by following the
instructions in
“Wall-Mounting a Stand-Alone Processor Module and a
2-Slot Carrier” on page 8 and “Inserting Batteries in the Processor
Module” on page 12 .
g Mount or remount the top module by following the steps in
“Wall-Mounting a Stand-Alone Processor Module and a 2-Slot Carrier”
on page 8
.
5 Connect the line and extension cords one at a time, making sure to place
the correct cords into their corresponding jacks on the new module. (See
“Connecting Lines and Extensions” on page 16 .)
6 Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush
against the plastic case. Do not install the power cord at an angle to
the case or with a loop in it.