Samsung RF24FSEDBSR - Manual (Page 125)

Safety information _05
The refrigerator should always
be plugged into its own
individual electrical outlet
which has a voltage rating that
matched the rating plate.
- This provides the best
performance and also
prevents overloading house
wiring circuits, which could
cause a fi re hazard from
overheated wires. If the wall
socket is loose, do not insert
the power plug.
- There is a risk of electric shock
or fi re.
• Do not use a cord that shows
cracks or abrasion damage
along its length or at either
end.
• Do not bend the power cord
excessively or place heavy
articles on it.
• Do not use aerosols near the
refrigerator.
- Aerosols used near the
refrigerator may cause an
explosion or fi re.
• Do not install this appliance in
a location where gas may leak.
- This may result in an electric
shock or fi re.
• The installation or any
service of this appliance
is recommended by a
qualifi ed technician or
service company.
- Failing to do so may result
in an electric shock, fi re,
explosion, problems with the
product, or injury.
• This refrigerator must be
properly installed and located
in accordance with the manual
before it is used.
• Do not install the refrigerator in
a damp place or place where
it may come in contact with
water.
- Deteriorated insulation of
electrical parts may cause an
electric shock or fi re.
• Connect the power plug in
proper position with the cord
hanging down.
- If you connect the power plug
upside down, wire can get
cut off and a cause fi re or an
electric shock.
• Do not use a cord that shows
cracks or abrasion damage
along its length or at either
end.
• Make sure that the power plug
is not squashed or damaged
by the back of the refrigerator.
• When moving the refrigerator,
be careful not to roll over or
damage the power cord.
- This constitutes a fi re hazard.
DA68-02916G-08.indb 05 DA68-02916G-08.indb 05 2014. 6. 20. 9:20 2014. 6. 20. 9:20