Nilfisk-ALTO DJM-3 - Manual (Page 7)

3.1.1 The CHANNEL Section
-. PHONO-LINE to LINE switch
This switch is available on both input channels. You shall
use the LINE position for all high level audio signals such
as CD Players, DAT, MD, etc. You shall use the PHONO-
LINE position to connect the turntables making sure that
the PHONO-LINE switch on the rear panel is on PHONO
position. With this switch (the one on the rear panel) on
LINE position, the Input Channel will accept a high level
audio signal.
-. The GAIN control
Via this knob you will adjust the input level. Do not turn
this control too much clockwise or you will overload the
channel but do not turn it too much counterclockwise or
you will generate background hiss.
-. The EQUALIZER control
Both Input Channels are provided with 3 bands equaliser:
Bass, Middle and Treble and you can adjust the gain range
of each from -30dB to +15dB.
-. The PROGRAM Fader
There is a Program Fader available on both channels. For
optimum performance and operation the 2 Faders are VCA
(Voltage Control Amplifier) controlled. These Faders adjust
the overall level of the input channels.
-. The CURVE control
Both input channels include a 3-position switch denominated
CURVE.
If you set the CURVE switch on SHARP position the level
will be changed quite quickly by the PROGRAM Fader even
if you move the Fader slowly.
If you set the CURVE switch in SOFT position, the level will
be changed much more slowly by the PROGRAM Fader
even if you move the Fader quickly.
If you set the CURVE switch in MID position you will combine
the SHARP and SOFT configuration.
3.1.2 The MIC INPUT Section
-. LEVEL control
You can adjust the level of the microphone signal via this
control.
-.TREBLE and BASS controls
With the treble and bass control you can create sound effects
and make the sounds of any microphone better. The gain
range of both bass and treble controls is of -15dB to +15dB.
-. The MIC ON switch
Push the MIC On button to activate the MIC INPUT channel.
6
1
2
3
4
5
6
7
6
7
8
8
1
2
3
4
5 5