Nilfisk-ALTO DJM-3 - Manual (Page 8)

7
3.1.3 The MAIN OUT Section
-. LEVEL control
This knob controls the overall output volume.
-. The TALK control
When you speak through a connected microphone the
volume of the reproduced music will be automatically
reduced by the mixer for better intelligibility of your voice.
You can determine yourself how much the volume of the
music will be reduced via this control.
-. The SURROUND control
DJ Mixers are often used in quite inappropriate venues
and the positioning of the loudspeakers is not always
optimal. The Surround Control allow you to get a better
transparency and stereo image and will contribute to
"clean" you mix.
-.The SURROUND ON switch
You can turn off the Surround function via this switch.
You can also run fast A/B comparison (with surround/
without surround) via this switch.
3.1.4 The PFL (pre fader level) Section
When you connect a headphone to your DJM 3 you have the
chance of pre-listen the audio signal before the signal reach
the Main output.
-.LEVEL control
This knob will adjust the level of the headphone signal.
-.The MIX control
Set the switch mode (15) in STEREO position and you can
fade between channel 1 and 2.
-.MODE switch
This is a 2-position switch. When the switch is in STEREO
position see above at (14). If you choose the SPLIT position
the two channels will be fully separated. So you will hear
channel 1 only on the left side and you will hear Channel 2
only on the right side.
3.1.5 The LEVEL METER Section
9
10
11
12
13
15
9
10
11
12
13
14
15
16
17
14
-.LEVEL METER
This 10 segments LED's Meter will read the signal selected
via the MAIN/PFL switch. Please see following.
-.MAIN/PFL switch
When this switch is in MAIN function (main Led on) the Level
Meter will display the output level of the Left and Right channels;
When this switch is in PFL function (PFL Led on) the Level
Meter will display the PFL headphone signal: channel 1 on
left Led Meter and Channel 2 on right Led Meter.
17
16