Netdoubler™ installation and operation – Asante Technologies 10NIC-PCITM User Manual
Page 23
Page 3-7
Using the Asanté Ethernet Options Control Panel
Configuring Duplex Mode
To change an Asanté 10NIC-PCI adapter’s setting:
1
Click on the button corresponding to the slot containing your
card.
2
Click on the appropriate button to select either half duplex
or full duplex mode.
Full duplex is recommended if you are connected to an
Ethernet Switch.
If you are connected to an Ethernet Hub, select half duplex
mode (default setting). A hub cannot support full duplex
mode.
3
To change the setting for another Asante card, click on the
button for that slot and then set its duplex mode.
4
Close the control panel and restart the Macintosh com-
puter for the changes to take effect.
NetDoubler™ Installation and Operation
The Asanté 10NIC-PCI adapter supports free operation of Asanté’s NetDou-
bler Network Acceleration Software.
NetDoubler contains special code that detects the Asanté 10NIC-PCI adapter
and automatically enables the software on Power Macintosh computers
without the need for a NetDoubler serial number.
For installation instructions, refer to the NetDoubler diskette included in
your Asanté 10NIC-PCI adapter package.
You may also download free updates for NetDoubler from Asanté’s web site
at www. asante.com.