Asante Technologies 10NIC-PCITM - Manual (Page 26)

Page 3-10
Installing Network Drivers
10 Press Enter to exit to the DOS prompt.
11 Restart the computer to load the network drivers.
12 To log in to the network, type:
F:login
Microsoft Windows 95
This section explains how to install the driver to use your Asanté 10NIC-PCI
adapter with Windows 95.
D Note: If you are installing Windows 95 for the first time, the
Plug and Play technology of Windows 95 will automatically
detect the Asanté 10NIC-PCI adapter.
It will select, and ask to install, the generic “PCI Ethernet DEC-
chip 21041 Based Adapter” driver from the Windows 95 soft-
ware. Although this driver will work with the Asanté 10NIC-PCI
adapter, Asanté recommends you instead install the Asanté
driver.
The following instructions assume you have just installed the
10NIC-PCI adapter in a PC already equipped with Windows 95:
1 Start the computer.
During startup, Windows 95 will detect any new card in the
PCI bus and present a dialog box titled
New Hardware Found . It
will state the 10NIC-PCI is a “PCI Ethernet DECchip 21041
Based Adapter”.
After a few seconds, you will then see a
Network dialog box
stating that “You must provide computer and workgroup
names that will identify the computer on the network” (this
dialog will only appear if you have never previously con-
nected this computer to a network).
2 Click OK to dismiss this dialog box.
A different dialog box, again called Network , appears with
three tabs labeled Configuration , Identification , and Access
Control .