AAMP of America PXDX-KI - Manual (Page 13)

2.1 Installation Location
Most installations will require you to remove the factory radio in order to plug in the vehicle
specific harness. Some vehicles may require you to connect the interface to a factory pre-
run CD changer cable. The location of these CD changer cables will vary by vehicle. Some
common locations of these cables are in the trunk, behind the glove box, and in or under a
center console. ( see Fig.2 below)
2.2 Pre-Installation Checklist
At this time and before beginning the installation:
• You should have your radio’s security code.(when applicable, see section 1.2)
• The dip-switches on the interface should have been set with the proper configuration.
(see section 1.3)
• You should have in your possession the correct harness for your vehicle. (see sec. 1.3)
• You have determined your installation location. (see section 2.1)
If any of these steps has not been taken, STOP. Only when ALL of these steps have been
taken should you proceed with the rest of the installation.
11
Common Connection Locations
Fig. 2
Mobile Device
Audio2car
interface
Vehicle Specific Harness
Refer to Application Guide
for correct harness
Chapter 2- General Installation
2.3 Wiring Connections
Some vehicle specific harnesses require wiring connections that involve splicing of wires. If
you are not confident in making these connections to your radio’s wiring harness, we recom-
mend you seek professional installation. You can visit www.peripheralelectronics.com and
click on the dealer link at the top of the page to find an authorized professional installer.
Make these connections only after verifying the proper circuit on your radio harness with a