Aiwa XD-DV270 - Manual (Page 14)

14
ENGLISH
CONNECTIONS (CONTINUED)
D Connecting to an AV receiver equipped with a Dolby Digital (AC-3) or DTS decoder
Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV receiver with
a Digital In jack. The supplied video cord is also available instead of the coaxial cord.
TV set
Rear of the unit
Front
speaker (R) Front
speaker (L)
Optical cord (not supplied)
Receiver equipped with a Dolby
Digital decoder or DTS decoder
Video cord
(supplied)
to a video input jack
(yellow)
to an AC outlet
to DIGITAL AUDIO
OUT OPTICAL jack
to a digital input jack
Center speaker Subwoofer Surround speaker (R) Surround speaker (L)
Set the setup menu correctly after connecting!
According to the audio equipment and TV set to which this
unit is connected, set the “AUD OUT” and “TV TYPE” of
the setup menu correctly referring to the following below
.
See “CHANGING SETUP VALUE” on page 32 in detail.
AUD OUT
[BITSTREAM]
TV TYPE
When your TV set is a conventional-screen size TV:
[4:3 LB ]
When your TV set is a wide-screen size TV:
[16:9 ]
NOTE
When the picture noise appears while copy-protected DVDs
are played, connect the unit directly to a TV set. Do not
connect through a VCR, TV/VCR or AV selector .
CAUTION
If the AV receiver is not equipped with a Dolby Digital or
DTS decoder, do not select “BITSTREAM” in the “AUD
OUT” when connecting the AV receiver with an optical or
coaxial connecting cord.
Merely attempting to play a DVD may cause a high level of
noise which could be harmful to your ears and damage the
speakers. In such a case, be sure to select “DIGITAL PCM”
in the “AUD OUT”.
to DIGITAL AUDIO
OUT COAXIAL jack
yellow
to VIDEO OUT 1 or 2
jack (yellow)
When your TV set is equipped with an S-video input terminal, see page 16.
S-VIDEO VIDEO
OUT
AUDIO OUT
OPTICAL COAXIAL
DIGITAL
AUDIO OUT
L R
yellow
Rear of the unit
Coaxial cord
(not supplied)