Avenview Cat5 - Manual (Page 10)

www.avenview.com 10
d. Connect the Cable: Plug one ends of UTP cable to DVI-C5-S Transmitter’s “LINK IN/OUT”
port and the other end to the DVI-C5-R Transceiver’s “LINK IN/OUT” port. The monitor
connected to the Transceiver should now display and the “LINK” LED should turn green to
indicate the DVI signal activation.
Installation Diagram of DVI-C5-S and DVI-C5-R
e. Extending Audio Signals: The DVI-C5-S Transmitter and DVI-C5-R Transceiver are not able to
extend audio signals. Use a pair of Avenview AUD-RJ11 Audio Extenders with 4-wire phone
cable and RJ11 connectors to extend the audio signal.
General Troubleshooting
Problem
Possible Solution
Off-Center Screen Image, Odd
Colors or No Picture

Try adjusting the brightness, sharpness, contrast, and color
balance controls of your monitor.

Try adjusting the centering and positioning controls of your
monitor to position the picture on the screen.
No Image

Ensure that the monitor cable is securely fastened to the DVI
and Monitor port.
Use EQ control to adjust the video quality for best signal.