Avenview Cat5 - Manual (Page 7)

www.avenview.com 7
e. EQ Adjustment: You can adjust the EQ control to Auto mode by rotating the EQ control
Anticlockwise. The “EQ” and “AUTO” LEDSs will display blue.
f. EDID Simulation: The Transmitter has built-in EDID simulator. When local DVI monitor is
connected to Transmitter, it will automatically record the EDID data from DVI Monitor.
When a local DVI monitor is not connected the Transmitter will simulate the EDID data and
activate the DVI signal on the PC or DVD Player.
DVI-C5-R Installation
a. First Time Connection: Connect DVI Monitor’s DVI Cable to the receiver and TURN ON the
monitor.
b. Device Connection: Plug power adapter to DVI-C5-R (Transceiver), the “PWR” LED and “M1
LINK” will turn ON. The other “LINK” LED should turn off because there is no input of video
signal from “LINK IN” port.
c. EQ Adjustment: You can adjust the EQ control to Auto Mode by rotating the EQ
Anticlockwise. The “EQ” and “AUTO” LEDs will turn ON Blue.
You can also adjust the EQ control for better image display. This changes the EQ into manual
mode. The “EQ” and “AUTO” LED will turn off to indicate the manual EQ Mode.
If noise or unstable image is seen on the local DVI monitor, it indicates the DVI signal
received by the Transmitter needs to be adjusted.
After connecting the extender system, if you see dynamic dots on unclear image on
the DVI, you need to adjust the signal from Transmitter.