Aruba Spa Hot Tub Models 2003 - Manual (Page 10)

9
ELECTRICAL CONNECTION ELECTRICAL CONNECTION
A certified electrician must make all electrical connections to
your spa, in accordance with all applicable electrical codes
for your area. The spa’s GFCI breaker must be sized in accor-
dance to electrical requirements of the spa. The Full Load
Amperage (FLA) is recorded on the spa’s nameplate.
ELECTRICAL CONNECTION ACCESS
To access Electrical connections:
Electrical connections are within the spa pack. There are 2
wire access locations, one on each side of the front panel. The
electrical requirements are 220V with a neutral.
IMPORTANT SAFETY INSTRUCTIONS
1. Read and follow all instructions.
2. A ground terminal is located on the power connection ter-
minal block. To reduce the risk of electric shock this terminal
must be connected to the grounding means provided in the
electric supply service panel with a
L2
N
GND
L1
WARNING
Failure to use a GFCI breaker for electrical
connection to your spa could result in seri-
ous harm or death. No electrical power
should be available near the spa without
GFCI protection.
WARNING
Electrical codes change from Province to
Province. Check with your electrician for
the electrical codes in your area.