Allied Telesis AT-SBx81CFC960 - Manual (Page 308)

Chapter 15: Building a Stack
308 Section III: Building a Stack with VCStack Plus
4. Do one of the following:
 If the SHOW STACK command is displaying all the controller cards
in the stack, the stack is operating normally. If you have optional
feature licenses to install, go to “Installing Optional Feature
Licenses” on page 309. Otherwise, you may begin to configure the
parameter settings of the ports and features of the stack with the
commands in the command line interface. For instructions, refer to
Software Reference for SwitchBlade x8100 Series Switches.
 If the SHOW STACK command is displaying the controller cards
from only one chassis, the switches were not successful in forming
the stack. Go to “Troubleshooting the Stack” on page 310.