Allied Telesis AT-FS970M Series - Manual (Page 299)

AT-FS970M Series Version 2.3.1.0 Web Interface User’s Guide
299
The LLDP Coordinate Location page is displayed. See Figure 133.
Figure 133. LLDP Coordinate Location Page— Add
6. Specify the following fields as needed:
 ID— Enter an LLDP Coordinate Location ID. The range is 1 to 256.
(This range is separate from the ranges for civic and ELIN entries.)
 Latitude— Enter a latitude value in decimal degrees. The range is
-90.0º to 90.0º. The field accepts up to two digits to the right of the
decimal point.
 Latitude Resolution— Enter latitude resolution as the number of
valid bits. The range is 0 to 34.
 Longitude— Enter a longitude value in decimal degrees. The
range is -180.0º to 180.0º. The field accepts up to two digits to the
right of the decimal point.
 Longitude Resolution— Enter longitude resolution as the number
of valid bits. The range is 0 to 34.
 Altitude— Enter an altitude in meters or floors. For the altitude in
meters, the range is -2097151.0 to 2097151.0 meters. The
parameter accepts up to eight digits to the right of the decimal
point. For altitude in the number of floors, the range is -2097151.0
to 2097151.0. Use the Altitude Type field to specify meters or
floors.