Allied Telesis AT-FS970M Series - Manual (Page 46)

Chapter 3: Basic Switch Parameters
46
Note
Both the Remote Log and Server IP Address fields are used only to
set a remote log server. For information on these fields, see
“Configuring a Remote Log Server” on page 47.
 Remote Log— Check the checkbox to enable the switch to send
status and error messages to a remote log server. To disable the
switch to send messages to a remote log server, uncheck the
checkbox.
 Server IP Address— Enter the IPv4 address of the remote log
server if you check the Remote Log checkbox above. Enter the IP
address in the IPv4 format: nnn.nnn.nnn.nnn.
5. Click Apply.
6. Click SAVE to save your changes to the startup configuration file.