Allied Telesis AT-GS950/10PS - Manual (Page 307)

AT-GS950/10PS Switch Web Interface User’s Guide
307
LLDP TX Delay: Sets the value of the transmission delay timer,
which is the minimum time interval between transmissions of LLDP
advertisements due to a change in LLDP local information. The
range is from 1 to 8192 seconds.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Displaying
System
Information
To display system information about the switch, do the following:
1. From the main menu on the left side of the page, click the LLDP folder.
The LLDP folder expands.
2. From the LLDP folder, select LLDP Global Setting.
The AT-GS950/10PS LLDP Global Settings Page is displayed.
See Figure 121 on page 305.
3. The following parameters display the system information:
Chassis ID Subtype: This parameter describes the Chassis ID
subtype which is “macAddress”. You cannot change this
parameter.
Chassis ID: This parameter lists the MAC Address of the switch.
You cannot change this parameter
System Name: This parameter lists the System Name of the
switch. You can assign the system name. For more information,
see “System Management Information” on page 28.
System Description: This parameter lists the product name of the
switch. You cannot change this parameter
Setting Port
States
Each port on the switch can be assigned a LLDP states as follows:
1. Refer to the lower section of Figure 121 on page 305 for the LLDP port
states.
2. In the State column, select one of the following states from a port’s
pull-down menu:
Disabled: Indicates LLDP is disabled on the port. The port can not
receive or transmit LLDP data packets.
Enabled: Indicates LLDP is enabled on the port. The port can
receive and transmit LLDP data packets.
RxOnly: Indicates LLDP is enabled on the port. The port can
receive LLDP data packets.
TxOnly: Indicates LLDP is enabled on the port. The port can