Allied Telesis SwitchBlade x8106 - Manual (Page 185)

SwitchBlade x8106 Chassis Switch Installation Guide
185
2. Connect the other end of the cable to an RS-232 port on a terminal or
personal computer with a terminal emulation program.
3. Configure the VT-100 terminal or terminal emulation program as
follows:
 Baud rate: 115,200 bps
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow controller: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter. You are prompted for a user name and password.
5. Enter the default user name and password. They are “manager” and
“friend” (without the quotes), respectively
Note
User names and passwords are case sensitive.
The local management session starts and the command line interface
(CLI) prompt is displayed.
Entering the
AlliedWare Plus
Operating System
Commands
To confirm the operations of the chassis with the commands in the
AlliedWare Plus Operating System, perform the following procedure:
1. Enter the SHOW VERSION command in the User Exec or Privileged
Exec mode to display the software version number of the AlliedWare
Plus Operating System on the controller card, as shown in Figure 135
on page 186.