Allied Telesis AT-2912T - Manual (Page 25)

AT-2712FX/SC and AT-2912T Secure Ethernet Network Adapter Installation and User’s Guide
25
Replacing the Bracket
The AT-2712FX/SC adapter is shipped with the low-profile bracket
attached to the adapter. The AT-2912T adapter is shipped with the
standard bracket attached to the adapter. Depending on your PC, you may
need to replace the bracket attached to your adapter.
The following procedure describes how to remove the low-profile bracket
from the adapter and replace it with the standard bracket. You can also
use this procedure to remove the standard bracket and replace it with the
low-profile bracket.
To replace the low-profile bracket with the standard bracket, perform the
following procedure:
1. Remove the screws that attach the bracket to the adapter. See
Figure 5.
Figure 5. Removing the Low-Profile Bracket
1479
TX
RX
100