Allied Telesis AlliedView-EMS 4.0.1 QoS MANAGER - Manual (Page 105)

AlliedView™-EMS 4.0.1 QoS Manager User’s Guide Page 105 of 146
Property Name Description Valid Values
of the bit at the same position in the
byte value of the MAC address is
used to determine a match. If a bit
in the Source MAC Address
parameter is 0, the corresponding
bit in the Source MAC Address
parameters is ignored.
• XX-XX-XX-XX-XX-XX
This can also be set to "any".
Destination MAC
Address Mask
Specifies the masks to be used on
the Destination MAC Address.
When a bit is set to 1 in the mask,
the value of the bit at the same
position in the byte value of the
MAC address is used to determine a
match. If a bit in the Destination
MAC Address parameter is 0, the
corresponding bit in the Destination
MAC Address parameters is
ignored.
This can be set by entering a MAC
address string using the following
format:
• XX-XX-XX-XX-XX-XX
This can also be set to "any".
MAC Type Specifies whether the packet is a
Layer 2 unicast (L2UCAST), Layer 2
multicast (L2MCAST) or Layer 2
broadcast Ethernet (L2BCAST).
• L2UCAST
• L2MCAST
• L2BCAST
• any
Tag Protocol ID Specifies the Tag Protocol Identifier
field in the packet.
This can be set by entering a 4 digit
hex number from 0000-FFFF.
This can also be set to "any".
VLAN Priority Specifies the 802.1P priority in the
VLAN tag.
Range: any, 0-7
VLAN Specifies:
• For IPv4 packets and
switched Layer 2 IPv6
packets, the source VLAN
that the packet was
associated with at the time
of classification.
• For accelerated IPv6 packets
at the Layer 2 processor of
the accelerator card, the
destination VLAN.
This can be set by selecting from a
list of available VLANs or "any".
Inner Tag
Protocol ID Specifies the TPID in the second
802.1Q tag in the packet. This can be set by entering a 4-byte
hex number from 0000-FFFF.
This can also be set to "any".
Inner VLAN Specifies the second 802.1P field in Range: any, 0-7