Show bootvar – Allied Telesis AT-S95 CLI User Manual
Page 83
Configuration and Image File Commands
Page 71
show bootvar
The show bootvar Privileged EXEC mode command displays the active system image file that is loaded by the
device at startup.
Syntax
show bootvar [unit unit]
Parameters
•
unit — Specifies the unit number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the active system image file that is loaded by the device at startup.
interface ethernet 1/g1
ip address 176.242.100.100 255.255.255.0
duplex full
speed 1000
interface ethernet 1/g2
ip address 176.243.100.100 255.255.255.0
duplex full
speed 1000
Console# show bootvar
Images currently available on the FLASH
image-1
active
image-2
not active (selected for next boot)
Unit
Active Image
Selected for next boot
----
------------
----------------------
1
image-1
image-2
2
image-1
image-1