Allied Telesis AT-S63 - Manual (Page 53)

AT-S63 Management Software Features Guide
53
History of New Features
The following sections outline the history of the new features in the
AT-S63 Management Software.
Version 3.2.0
This release added support for these features in stacks of Basic Layer 3
AT-9400 Switches:
ˆ Remote web browser management
ˆ Link Aggregation Control Protocol (LACP) trunks
ˆ Internet Group Management Protocol (IGMP) snooping
ˆ Internet Protocol Version 4 packet routing with static routes (Stacks do
not support the Routing Information Protocol (RIP) or multipath
routing.)
ˆ Basic 802.1x port-based network access control (Stacks do not
support MAC address-based authentication, Guest VLANs, or
supplicant and VLAN associations.)
For a complete list of the features supported in a stack, refer to the
Software Release Notes for the AT-S63 Version 3.2.0 Management
Software or to the AT-S63 Stack Command Line User’s Guide.
Version 3.2.0 did not include any new features for stand-alone AT-9400
Switches.
Version 3.0.0
Table 5 lists the new features in version 3.0.0 of the AT-S63 Management
Software.
Table 5. New Features in AT-S63 Version 3.0.0
Feature Change
Stacking with the AT-StackXG
Stacking Module New feature. For information, refer
to Chapter 1, Overview in the
AT-S63 Stack Command Line
Interface User’s Guide.
Virtual Router Redundancy
Protocol (VRRP) New feature. For information, refer
to Chapter 30, “Virtual Router
Redundancy Protocol” on page
343.
Ethernet Protection Switching
Ring (EPSR) snooping New feature. For information, refer
to Chapter 19, “Ethernet
Protection Switching Ring
Snooping” on page 193.