Allied Telesis AT-S88 - Manual (Page 54)

Chapter 5: SNMP
46
Setting Up the SNMP Community Table
To define the SNMP community names and their settings, perform the
following procedure:
1. From the main menu, select SNMP > Community Table.
The Community Table page is shown in Figure 13.
Figure 13. (SNMP) Community Table Page
2. To add a community name, enter it in one of the Community Name
fields.
3. To allow read/write access for any community name, click the
adjoining box in the Set column.
If you do not click Set for a particular community name, that
community name has read access only.
4. Do one of the following:
ˆ Click OK to save the community names.
ˆ Click Reload to clear the fields and start over.
5. To permanently save these settings in the configuration file, from the
main menu, select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 13.
6. Click Save.