Configuring the snmpv3 notify table, Creating a notify table entry – Allied Telesis AT-S62 User Manual
Page 234
Chapter 19: SNMPv3
234
Section III: SNMPv3
Configuring the SNMPv3 Notify Table
You can create, delete, and modify an SNMPv3 Notify Table entry. See
the following procedures:
“Creating a Notify Table Entry” on page 234
“Deleting a Notify Table Entry” on page 236
“Modifying a Notify Table Entry” on page 237
For reference information about the SNMPv3 Notify Table, see
“Configuring the SNMPv3 Notify Table” on page 234.
Creating a Notify
Table Entry
To create an entry in the SNMPv3 Notify Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Notify Table. Then click Configure at the bottom of the page.
The SNMPv3 Notify Table Page is shown in Figure 71.
Figure 71. SNMPv3 Notify Table Page