Allied Telesis AT-2746FX - Manual (Page 66)

Chapter 3: Microsoft Windows 2000, 2003, and XP
66
11. If the card has not been installed, the prompt in Figure 21 is displayed.
Remove the CD from the CD driver and click Yes. The Windows
operating system and the system are automatically shut down. You
can now install the adapter card. For instructions, refer to Chapter 2,
“Installing a Network Adapter Card” on page 45.
Figure 21. Shut Down Prompt
Running
AT-Setup from a
Driver
Installation
Diskette
To install the network adapter driver using the AT-Setup utility from a
driver installation diskette, perform the following procedure:
1. Insert the driver installation disk into the floppy drive.
Note
For instructions on how to create a driver installation disk, refer to
“Creating a Driver Installation Disk” on page 68.
2. From the Start menu on the Window’s toolbar, select Run, as shown in
Figure 22.
Figure 22. Run Selection in the Start Menu