Disable interface linktrap – Allied Telesis AT-S62 User Manual
Page 152
Advertising
Chapter 8: Port Parameter Commands
152
DISABLE INTERFACE LINKTRAP
Syntax
disable interface=port linktrap
Parameter
port
Specifies the port where you want to disable SNMP
link traps. You can specify more than one port at a
time. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or
both (for example, 1,5,14-22).
Description
This command disables link traps on a port. When disabled, the switch
does not send an SNMP link trap when there is a change to the status of
a link on a port.
Note
In order for the switch to send SNMP traps to SNMP trap receivers,
you must activate SNMP on the unit and specify one or more trap
receivers.
Example
The following command disables link traps on port 21:
disable interface=21
Advertising