Allied Telesis AT-S62 - Manual (Page 91)

AT-S62 Command Line User’s Guide
91
❑ Management station IP addresses - These are the IP addresses of
management stations that can access the switch through a
community string that has a closed access status. (Management
station IP addresses are displayed only when you specify a specific
community string using the COMMUNITY parameter in this
command.) To add IP addresses of management stations to a
community string, refer to ADD SNMP COMMUNITY on page 75.
To delete addresses, refer to DELETE SNMP COMMUNITY on page
80.
❑ Trap receiver IP addresses - These are the IP addresses of
management stations to receive SNMP traps from the switch. (IP
addresses or trap receivers are displayed only when you specify a
specific community string using the COMMUNITY parameter in
this command.) To add IP addresses to a community string, refer
to ADD SNMP COMMUNITY on page 75. To delete addresses, refer
to DELETE SNMP COMMUNITY on page 80.
❑ Access Status - If a community string shows an Open Access with
Yes, the string has an open access status, meaning any
management workstations can use the string. A string with a
Open Access of No has a closed access status; only those
management workstations whose IP addresses have been
assigned to the string can use it. To change the access status, refer
to SET SNMP COMMUNITY on page 88.
Examples
The following command displays the SNMP status and the community
strings on the switch:
show snmp
The following command displays specific information about the
“private” community string. The information includes the IP addresses of
management workstations that can use the string and the IP addresses
of SNMP trap receivers:
show snmp community=private