Allied Telesis AT-WL2411 User Manual
Page 97
AT-WL2411 Installation and User’s Guide
97
7. Click Submit Changes to save your changes. To activate your changes,
click the Save/Discard Changes link in the menu bar and then click
Save Changes and Reboot. For help, see Saving Your Configuration
Changes on page 46.
To configure the IP address list:
1. From the main menu, click IP Tunnels and then click IP Addresses. The
IP Addresses screen appears, as shown in Figure 38.
Figure 38 IP Addresses
2. If you enabled IGMP, enter the Class D IP multicast address. The
default is 224.0.1.65.
3. Enter the IP unicast addresses of the access points that can be the
endpoints of IP tunnels.
4. Click Submit Changes to save your changes. To activate your changes,
click the Save/Discard Changes link in the menu bar and then click
Save Changes and Reboot. For help, see Saving Your Configuration
Changes on page 46.