Allied Telesis AT-8203 User Manual
Installation guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- AT8202 AT-8203
- Electrical Safety and Installation Requirements
- Uplink Card Installation
- Who Should Use This Guide
- About the ATM Uplink Card
- About the FDDI Uplink Card
- Verifying Your Uplink Package
- Prerequisites for Card Installation
- Installing the Uplink Card
- 1. Turn off power to the FORMULA8200.
- 2. Unplug the unit.
- 3. Disconnect and label all connections to the swi...
- 4. Remove additional hardware, such as rackmountin...
- 5. Remove the top cover from the unit, as follows:...
- 6. Using a #1 Phillips screwdriver, remove the scr...
- 7. Install the uplink card into the lower PCI slot...
- 8. Using the screw from Step6, secure the uplink ...
- 9. Proceed immediately to the next sections to ins...
- Installing the Accelerator Card
- Replacing the Chassis Top Cover
- Initializing the Switch
- Interpreting the LEDs
- Cabling Requirements for the FDDI Uplink Card
- Where to Go From Here
- In Case of Problems
- Product Specifications for the FORMULA8200 Switch...
- Technical Support Fax Order
- FORMULA 8200 Uplink Card Installation Guide Feedba...
- Lindfield, NSW
- Rexdale, Ontario
- Richmond,BritishColumbia
- Abingdon, Oxon
- Les Ulis
- Berlin
- Freising
- Mongkok
- Milano
- Machida-shi,Tokyo
- Yodogawa-ku,Osaka
- Scottsdale, AZ
- LosAngeles,CA
- Mission Viejo, CA
- SanDiego,CA
- Santa Ana, CA
- Clearwater,FL
- Norcross,GA
- Reading,MA
- Eden Prairie, MN
- St. Louis, MO
- Dover, NH
- Plaistow, NH
- Portsmouth, NH
- Morrisville, NC
- Lake Oswego, OR
- Austin,TX
- Dallas,TX
- San Antonio, TX
- Vienna,VA