Allied Telesis AT-S25 - Manual (Page 27)

AT-S25 Version 1.4 User’s Guide
27
Most of the procedures in this guide start by having you select the
switch in the stack on which you want to perform the procedure. For
example, to display the status of the ports on switch 3, you would first
select switch 3 from the bottom of the Main Menu and then choose Port
status and configuration.
The number of each switch in the menu corresponds to the Stack ID
setting on the switch. The Stack ID setting is assigned with the Stack ID
switch on the back panel of the switch. For the location of the switch and
information on how each switch is assigned a value, refer to the
AT-8316F/MT, AT-8316F/VF, AT-8316F/SC and AT-8324 Installation Guide.
Note
The master switch of the stack has the number 1. All other switches
are slave switches. When instructed by this manual to select the
master switch, be sure to select switch number 1.
Selecting Menu
Options and
Changing
Parameters
Activated options in the menus are preceded by the
!
symbol. In the
following example, the first option is activated:
Figure 5 Active Menu Option
Options in which you can provide a value contain an entry field and the
two buttons Enter and Reset, as shown in the following example:
Figure 6 Entry Field
After entering a new value, press <Return> or click Enter to activate the
new parameter setting on the switch. Changes to parameters are
activated immediately on the switch.
The Reset button queries the switch for the current parameter setting
and displays the setting in the entry field.