Allied Telesis AT-S25 - Manual (Page 41)

AT-S25 Version 1.4 User’s Guide
41
4. Enter or change the parameters as desired. Changes to a parameter
take effect immediately on the stack.
The parameters in the IP Parameters window are described below:
IP address
This parameter specifies the IP address of the stack. You must
specify an IP address if you intend to remotely manage the stack
using a web browser, a Telnet utility, or an SNMP management
program. If you leave this field blank, the stack will attempt to
obtain its IP parameters from a Bootp or DHCP server on the
network.
Subnet mask
This parameter specifies the subnet mask for the stack. You must
specify a subnet mask if you intend to manage the stack remotely
using a web browser, a Telnet utility, or an SNMP management
program.
Gateway address
This parameter specifies the default router’s IP address. This
address is required if you intend to remotely manage the stack
from a management station that is separated from the stack by a
router.
Domain name server
This is the IP address of the Domain Name Service (DNS). This
address is required if you are using this service.
Default domain name
This is the domain name to which the switch belongs. This is
recommended if you are using DNS.
Manager addresses
You can enter up to four IP addresses of network management
stations or servers that are to receive SNMP traps from the switch.
These parameters are optional.
Download password
This password is required when downloading AT-S25 image files
from one AT-8300 stack to another stack. The default password is
ATS25, displayed as a series of asterisks. You can keep the default
or change it. A stack can only accept software downloads from
another stack of the same product series if their download
passwords are the same. The software automatically searches for
this password during downloads without requiring you to enter it.