Allied Telesis AT-MC103ST/FSx - Manual (Page 36)

Translated Electrical Safety and Emission Information
24
Standards: This product meets the following standards.
U.S. Federal Communications Commission
Declaration Of Conformity
Manufacture Name: Allied Telesyn, Inc.
Manufacture Address: 960 Stewart Drive, Suite B
Sunnyvale, CA 94086 USA
Manufacture Telephone: 408-730-0950
Declares that the Product: Fast Ethernet Media Converters
Model Numbers: AT-MC101XL, AT-MC102XL,
AT-MC103XL, AT-MC103LH,
AT-MC103SC/FS3,
AT-MC103ST/FS3
AT-MC103SC/FS4,
AT-MC103ST/FS4
This product complies with FCC Part 15B, Class B Limits:
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiated Energy
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with instructions, may cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on; the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer
or registrant of this equipment can void your authority to operate this
equipment under Federal Communications Commission rules.
Warning: This product requires only Category 3, 4, or 5 shielded
twisted-pair cable for all 10 Mbps RJ-45 connections, and Category 5
shielded twisted-pair for all 100 Mbps RJ-45 connections to comply with
Class B emission limits. If not used with shielded cables, this product
may cause radio interference in which case the user may be required to
take adequate measures to reduce interference levels.