Hubbardton Forge 206101 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30648
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: This fixture is designed to be mounted on a standard wall
surface and may not be suitable for all applications. If installing in a non-
wood frame application, we recommend consulting a qualified builder
or electrician.
After installation, extra hardware and accessories may be left due to kits
being used on multiple products.
To Mount Fixture to Wall (Figures 1 & 2)
Component Parts
A Front Assembly
B Fixture
C Mounting Bracket
D Anchors (4)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Front assembly (A) and fixture (B) are shipped installed.
Parts are held together with a snap clip. To separate,
pull apart. Save parts for later use. (Figure 1)
3. Using two machine screws (not provided), fasten the
mounting bracket (C) to the electrical box.
Note: A new electrical box comes with screws. When replacing
a fixture, retain the existing screws for use with the new fixture.
4. If mounting bracket (C) can’t be mounted to the electrical
box, follow steps 5 through 7 to attach mounting bracket to
the wall using anchors (D).
5. Place the mounting bracket (C) over the electrical box being
sure to hold it plumb and level. With a pencil, mark the
location of all mounting holes in the mounting bracket (C)
on the wall behind.
6. Drill 1/4" holes in the locations marked on the wall. For holes
using anchors, place the tapered end of the anchors (D)
into the holes and gently tap them flush to the wall using a
light weight hammer.
B312
Flux Sconce Vintage Platinum 206101 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Continued)
D
F
G
C
E
E #10 Screws (4)
F Cupped Washer
G Ground Screw
H #8 Black Screws (4)
(Figure 1)
B
A
B
H