Blodgett BTT-16G - Manual (Page 6)

6
2.0 INSTALLATION INSTRUCTIONS
WARNING: Never use an open flame to check for gas leaks. Check
all connections for leaks using soapy water before use.
1. Ideally an exhaust system should be located directly above the appliance to remove
combustion gases and steam generated by the unit.
2. Appliance is intended for use on noncombustible floors. Minimum clearance from
combustible and noncombustible wall construction, 3" (76 mm) on sides and 6" (152
mm) from back.
3. Set the appliance in place and level using spirit level.
4. Appliance location must allow air supply to unit and obstruction free clearance for air
opening into the combustion chamber.
5. Make service connections as indicated.