Blodgett BTT-12E - Manual (Page 5)

5
1.0 INSTALLATION INSTRUCTIONS
1.
Position appliance on counter allowing sufficient rear clearance from wall to tilt
freely and completely without obstruction.
2.
Mark four corner locations of appliance base, as shown below.
3.
Remove appliance from counter and locate position of four holes as per drawing
detailed below. Drill four 7/16" diameter holes.
4.
Apply a continuous bead of Silastic or other equivalent sealant along the complete
perimeter edge of the appliance base.
5.
Use 5/16-18 Hex Cap Screws with suitable flat washers to bolt down. Screw
length must be 1-1/4 long plus counter top thickness.
6.
Wipe off excess sealant.
7.
A control box with power supply equivalent to Electrical Rating of appliance should
be located conveniently nearby.
8.
A waterproof electrical connection for power supply to console housing must be
provided.
9.
Ground appliance to terminal provided inside console housing.
10. Turn power ON and check for proper operation.