Swiftech APOGEE1 U - Manual (Page 4)

Copyright Swiftech 2006 – All rights reserved – Last revision date: 5-16-06 – One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:
[email protected] – URL: http://www.swiftnets.com - Information subject to change without notice
Intel® Xeon™ Socket 603/604
800 MHz FSB motherboards
Removal of the motherboard is normally not required. Simply remove your existing heatsink solution, and fasten the
Swiftech water-block instead using the provided hardware. See important note 2 in reference to metric vs. UNC
threaded standoffs.
ITEM NO. PART NUMBER DESCRIPTION QTY
.
1 90272A153-6-32x1-philips 6-32 x 1" Philips zinc plated screw 4
2 APOGEE-1U-K8-XEON-ASSY 1
3 SPACER-13LTS2501400697 Apogee - Nocona nylon spacer 4
4 4-40 nylon retaining washer 4-40 nylon retaining washer 4
5 spring-backplate retention spring (provided by motherboard vendors) 1
6 chassis 1
7 6-32 standoff 6-32 Standoffs 4
1
2
3
4
5
6
7
Important notes:
1. The spring back-plate (also referred to as “CEK spring”) is normally always provided with the motherboard since
this is an Intel mounting specification, and as such is not included with the Swiftech water-block. Swiftech offers this
item as an option for those users who are either missing it, or in need of a replacement.
2. Depending on the vendors, the standoffs provided with the chassis are either metric, or UNC (US standard). A
set of UNC 6-32 standoffs and counter-nuts is included with the Swiftech hardware to replace metric standoffs. To
verify whether your chassis is metric or UNC, try first with one of the screws provided with the swiftech hardware
PRIOR to installing the water-block by screwing it into one of the existing standoffs.