Swiftech H20 120 - Manual (Page 32)

Parts QTY PARTS QTY
MCW6000™ water-block 1 Spring loaded screw assemblies 2
Worm drive clamps 2 Sk8 hold-down plate 1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your
components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The following
instructions are subject to change without notice. Please visit our web site at
www.swiftnets.com for updates.
4
5
6
7
8
2
1
3
3
ITEM NO. Q TY. PART NO. DESCRIPTIO N
1 1 M C W 6000-R 2 M C W 6000 flat ba se wate r-block
2 1 S754-R ETENTIO N-r2 SK8 ho ld-down p late for AM D K8
3 1 K8_M otherboa rd AM D K8 (Athlon 64 & Op teron) m otherb oard+ pro cessor assy.
1 co unter-plate
1 m otherb oard
1 retention-fra m e
4 2 91772A158-6-32X1.75 6-32 x 1 3/4" p hilip s screw
5 2 93286A041-W A SHER zinc pla ted wa sher
6 2 885 spring
7 2 spa cer-205x140x773 tension lim iter
8 2 6-32 nylon reta ining washer 6-32 nylon reta ining washer
Figure 10
1. Preparing your motherboard
a. Remove the existing heat sink
b. Carefully clean the CPU.
c. Lightly coat the CPU with thermal compound. We recommend high quality thermal compound such as Arctic Silver or
equivalent. Application will vary depending on the type of processor. We recommend visiting www.arcticsilver.com for
detailed instructions.
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-12009 – F (562) 595-8769 – All content
Copyright Swiftech 2004 – Last edited 9-11-04 – Subject to revision without notice - 32 of 39 -