Amd® 64, fx, x2, sempron®, socket am2 – Swiftech H20 120 PREMIUM REV3 User Manual
Page 18
Copyright Swiftech 2007 – All rights reserved – Last revision date: 06-14-07 - Information subject to change without notice – URL:
http://www.swiftech.com
Rouchon Industries, Inc., dba Swiftech – 3400 Industry ave., suite 104, Lakewood, CA 90712 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 18 of 28
AMD® 64, FX, X2, Sempron®,
Socket AM2
AMD 64, FRX, X2, Sempron, Socket AM2
The Apogee water-block ships pre-installed with the multi-socket hold-down plate. In order to install your Apogee with
AMD’s AM2 socket, you will need to remove the existing hold-down plate first and replace it with the AM2 model as
follows:
Step 1: loosen all 4 screws using the included hex key,
and set aside the standard hold-down plate.
Step 2: place the AM2 hold-down plate on the Apogee
body, and fasten all four screws in cross pattern.
You can now use your Apogee with AM2 socket motherboards. Please read the common, and step by step installation
guidelines on page 11, then continue the installation as shown in the schematic hereafter.