Installation complete, Iii. d, Iv. p – Swiftech H20 120 PREMIUM REV3 User Manual

Page 27: V. a

Advertising
background image

Copyright Swiftech 2007 – All rights reserved – Last revision date: 06-14-07 - Information subject to change without notice – URL:

http://www.swiftech.com

Rouchon Industries, Inc., dba Swiftech – 3400 Industry ave., suite 104, Lakewood, CA 90712 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]

PAGE 27 of 28

10 C

OMPLETING THE INSTALLATION

Once your system has been fully tested for leaks, you may complete all the electrical and data connections to the
motherboard, Hard Drives, CD Roms, etc..

INSTALLATION COMPLETE!

III. D

RAINING THE SYSTEM

Disconnect the PC from AC power

You will need to disconnect a line from one of the lowermost components. Procure a bucket large enough to receive
approximately 1 liter of fluid, and place the bucket underneath the connection that you intend to “break”. Disconnect
the line, and place both ends into the bucket.

Open up the fill-cap from the MCRES-1000P. This will allow most of the fluid to escape.

A cleaner and much more convenient method consists in incorporating a drain assembly into the circuit during initial
installation. See

TV500

drain assembly below.

IV. P

ERIODIC MAINTENANCE

Every 6 months: dust off the radiator fins and fan. You can use a can of compressed air for example,
available in most electronic supply stores. If you live in a very dusty area, you should perform this task at
closer intervals. It is essential to maintain the optimum performance of your cooling system.

Inspect the level of liquid inside the circuit, and refill if necessary. Evaporation in this closed circuit is limited,
but still present due to permeability in the vinyl lines. Typical time between refills varies from 12 to 18 months.

V. A

DD

-

ON COMPONENTS

Improve performance with a second radiator:

MCR120-FK Radiator assembly

Part # MCR120-FK, includes radiator, 120mm fan

and mounting screws

Cool your graphics card with the MCW60 VGA water-block.

Go to:

http://www.swiftnets.com/products/mcw60.asp

for

specifications

Part # MCW60

Advertising