Swiftech H20 220 APEX ULTRA PLUS - Manual (Page 25)

Copyright Swiftech 2006 – All rights reserved – Last revision date: 06-19-07 - Information subject to change without notice – URL: http://www.swiftech.com
Rouchon Industries, Inc., dba Swiftech – 3700 Industry Avenue, Suite 104, Lakewood, CA 90712 – Toll free (US): 888-857-9438 – Fax 562-595-8769 - E Mail: help@
Swiftech.com PAGE 25 of 35
Installation with nVidia GeForce 6800 to 7900 series & ATI X1800 and above (four mounting holes)
ITEM NO. PART NUMBER DESCRIPTION QTY
.
1 MCW60 WATER-BLOCK 1
2 1-4-NPSMx3-8-barb 1/4" NPSM X 3/8" Barb fitting 2
3 MCW60-HDP-R2 MCW60 HOLD-DOWN PLATE R2 1
4 MCW60-CB-R2 MCW60 CROSS-BRACKET R2 1
5 MCW60-2-56-PFH-CS 2-56 CUSTOM SCREW 4
6 REFERENCE VGA ADAPTER 1
1
3
2
6
4
5
·
Remove the existing heatsink
· Clean off the GPU with a degreaser, and spread some of the included thermal compound over it.
· Position the MCW60 over the GPU, aligning the 4 feet of the hold-down plate to the circuit board thru-holes
· Insert screws #5 thru cross-bracket #4, thru the circuit board, and fasten them into the legs of hold-down plate #3,
tightening the screws gradually and in a cross pattern.
·
Installation of the water-block is now complete