Swiftech H20 80 User Manual
Swiftech Computer Accessories
Advertising
H
H
2
2
0
0
-
-
8
8
0
0
L
L
I
I
Q
Q
U
U
I
I
D
D
C
C
O
O
O
O
L
L
I
I
N
N
G
G
K
K
I
I
T
T
S
S
TUTORIAL & INSTALLATION GUIDE
These instructions are updated on a regular basis. Please visit our web site at
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28
th
St, signal Hill, CA 90755, USA – T (562) 595-8009 – F (562) 595-8769 – All content Copyright
Swiftech 2004 – Last edited 9-11-04 – Subject to revision without notice
- 1 of 38 -
Advertising
Table of contents
Document Outline
- Preamble
- Remove the existing heat sink
- Carefully clean the processor, using alcohol
- Install the 4 neoprene pads as shown figure 8. This steps is only necessary if the processor core is exposed. If the chipset features a heat spreader (a large lid covering the entire area of the chipset), then the neoprene pads MUST not be installed.
- Lightly coat the processor with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied using preferably a razor blade, or a credit card, held between thumb and index at a 45( angle